Please enable Javascript And Refesh (F5)

ELECTROMECHANICAL DECIMAL TO BINARY TO HEXADECIMAL CONVERTER - BlueXanh.Com

ELECTROMECHANICAL DECIMAL TO BINARY TO HEXADECIMAL CONVERTER

Picture of Electromechanical Decimal to Binary to Hexadecimal Converter
Epilog Challenge 9This is an entry in the
Epilog Challenge 9

It is using an ESP32 equipped with an OLED display, two mechanical 7 segment displays and 14 relays. I’m using two NXP MC33996’s along with the DPDT relays in an h-bridge configuration. To set(display) each individual segment it needs at least a 1ms pulse and to reset the segment it needs to be pulsed with the opposite polarity. This was a proof of concept before I design a much larger clock with 6 digits and 46 relays with two sets of flip dots as colons. The sound is amazing and I could not be happier with how it turned out.

Step 1: Bill of Materials

(1 ×) ESP32 with OLED Display

(2 ×) Mechanical 7 Segment Displays

(11 ×) LEDs – 0805 SMD

(1 ×) Dual Voltage Power Supply – RD-50A MEAN WELL

(11 ×) 180 ohm Resistors for LEDs – 805 SMD

(3 ×) 470uF Electrolytic Capacitors

(2 ×) 47uF Electrolytic Capacitors

(3 x) Momentary Push Button – SMD

(3 ×) 10K Pull-up Resistors – 805 SMD

(14 ×) DPDT Relays

(14 ×) Schottky Diodes – 1.5KE18CA-T – Used as flyback diodes for the relays

(14 ×) TVS Diodes – 1.5KE18CA-T – Used as flyback diodes for the AC segment coils

Here is an overview of the mechanical 7 segment displays:

Step 2: Schematic With PCB Build Files

Picture of Schematic With PCB Build Files

You can order the board shown in the video from a PCB manufacturer or you can solder it up on your own with through hole components if you’d like with my schematic.

Step 3: Solder the PCB

In this video I use a stainless steel solder paste stencil to perfect put solder where I want. I use a hotplate set to 170C and a hot air gun to solder the SMD components.

Step 4: Program the ESP32 With the Arduino IDE

Picture of Program the ESP32 With the Arduino IDE

Download the Arduino core for the ESP32 here:

Download my attached source code and program your ESP32 with the Arduino IDE.

Step 5: Questions?

Thank you for reading my Instructable. Let me know if you have any questions and I will be happy to answer what I can.

Anthony Garofalo(Proto G)

Reply